Dayton 1RVT8 User Manual download pdf (Page 16)

Dayton Installation, Operation, Maintenance and Parts Manual

Dayton Patio Heaters

1RVT7 and 1RVT8

NOTICE

WARNING

Incorrect or improper wiring may result in

shock, injury or death. Field wiring to the

heater must be connected and grounded in

accordance with national, state, provincial,

local codes and to the guidelines in this

manual. Refer to the most current revisions to the ANSI/

NFPA 70 Standard.

Control systems are initiated by 120V control voltage.

Important! Proper grounding and polarity are essential.

If the system is not properly grounded, it cannot

determine the presence of a ﬂame and will lockout and

shut off.

Electrical Requirements

Figure 2.9 - 120V Typical Field Wiring

Radiant heat may damage the ﬂexible power cord.

Always keep the ﬂexible power cord away from the

heater. Do not allow the power cord to be subjected to

radiant heat.

Neutral

Hot

Mounting

bracket

120V thermostat,

timer or switch

(ﬁeld supplied)

Heater

For wiring of controls see Figure 2.9 below. It is

recommended that the control be installed on the hot

side of a fused supply line and have a sufﬁcient ampere

capacity rating for the heater(s) it will control (see

Figures 3.1 & 3.2).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Dayton 1RVT8 User Manual Page 16