Dayton 1RKU2 Operations Instructions download pdf (Page 10)

10

E

N

G

L

I

S

H

Dayton Operating Instructions and Parts Manual

Dayton

®

Generator

2ZRR1

Symptom Possible Cause(s) Corrective Action

Troubleshooting Chart

Engine will not start

Generator has no output.

Engine switch is off.

Fuel Tank empty.

Inadequate engine oil.

No spark at spark plug.

Circuit breakers tripped.

Inadequate cord sets or extension cords.

Turn engine switch to the ON position.

Fill tank per instructions in this manual.

Check oil level. This engine is equipped

with a low oil sensor. The engine cannot

be started unless the oil level is above

the prescribed lower limit.

Remove the spark plug cap. Clean any

dirt from around the plug base, then

remove the spark plug. Install the spark

plug in the plug cap. Turn the engine

switch on.

Grounding the electrode to any engine

ground, pull the recoil starter to see if

sparks jump across the gap. If there is no

spark, replace the plug.

Reinstall the plug and start engine

according to instructions in this manual.

Consult Customer Service.

Reset circuit breakers.

Check cord sets or extension cords

capabilities in section Controls; Cable

Size in this manual.

Consult Dayton Customer Service.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Comments to this Manuals

No comments