8
E
N
G
L
I
S
H
Dayton Operating Instructions and Parts Manual
Dayton
®
Generator
2ZRR1
5. Clean the air filter elements if they
are to be reused:
FOAM FILTER ELEMENT: Wash the
foam filter element in warm water
with detergent. Rinse the foam filter
element thoroughly until all traces of
detergent are eliminated. Squeeze out
excess water, but do not wring. Allow
the foam filter element to air dry.
Saturate the foam filter element with
new engine oil. Squeeze out all excess
oil. DO NOT put engine oil on the foam
damper.
NOTE: Clean the foam filter element
every 25 hours of operation (more
often under extremely dusty or dirty
condition)
PAPER AIR CLEANER ELEMENT: Do
not wash the paper element or use
pressurized air, as this will damage the
element. Clean by gently tapping the
element to remove dust. Replace the
element if damaged, bent or extremely
dirty. Handle new element carefully; do
not use if the sealing surfaces are bent
or damaged.
NOTE: Replace the paper element every
100 hours (more often under extremely
dusty conditions.)
6. Wipe dirt from the inside of the air
cleaner body and cover, using a
moist rag. Be careful to prevent dirt
fromentering the air chamber that
leads to the carburetor.
7. Place the foam air filter element in
the air cleaner cover. If applicable,
reinstall the paper air filter element
and cover to the air cleaner case.
Replace cover securely.
CLEANING AND GAPPING SPARK PLUG:
If the plug is contaminated with carbon,
remove it using a plug cleaner or wire
brush. Check the spark plug gap and
reset it if necessary. The spark plug
Maintenance Chart
Check Fuel X
Check Engine Oil X
Check for loose or lost nuts and bolts X
Check for leaks X
Check cylinder and head fins for
dust and dirt X
Check battery electrolyte level X
Check fuel lines (replace if necessary) X
Clean air cleaner foam element (**) X
Tighten nuts and bolts (*) X
Change engine oil X
Clean fuel filter X
Replace air cleaner paper element X
Clean dust and dirt from cylinder and X
cylinder head fins (**) X
Clean and regap spark plug X
Add fuel stabilizer X
Run unit dry X
* Perform these operations after the first 5 hours of use, then at the recommended intervals.
** Service more frequently under dusty conditions.
NOTE: These items must be performed with the proper tools. See your Dayton Customer Service Representative
for service, unless you have the proper equipment and mechanical proficiency.
Procedure
Daily
Every
25 hrs.
Every
100 hrs.
Every
200 hrs.
Before
Storage
Spark Plug Gap
(See recommendations)
(28 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals